Search results

Good morning, thanks in advance for your responses and apologies for the long read. I'm considering having a Kohler Standby generator installed (professionally) at my home. In a perfect scenario, I'll be fueling via our existing natural gas supply from our utility company. I'm looking for...

Before I get down to business wanted to say thank you in-advance for your time and suggestions. Your responses are very much appreciated. Also, wanted to dive on my sword for making a bad rookie mistake in laying out this vanity and cue some well deserved laughter from the group. Here's my...

G'day. In installing a new toilet I accidentally popped the closet flange off of the 3" copper riser. I replaced the flange with a multi-purpose PVC replacement flange that slipped into the riser. (the replacement riser was the type that had a 6" tail-piece with a gasket on the outside of...

I am looking to replace a length of basebord on my heating system. I have a gas fired boiler and hydronic base-boards throughout my house. My question is what is the proper way to drain the plumbing system and also the proper way to refill the system after I connect the new base-board...

Hey folks, I was wonderin' if any of ya would take a look at this question I posted over in John Bridge (link below) and give me your thoughts. Thanks a bunch. http://www.johnbridge.com/vbulletin/showpost.php?p=698866&postcount=28

I am planning a new circuit. It will be a 15 amp circuit running from the panel to a four gang box. The circuit will power a bathroom fan and three light fixtures. In order to wire the four switches I'll need to make a pigtail from the line to each switch in the four gang box. That means...