Search results

Hi! I moved and installed my softener from my old place. I unfortunately can find my old settings I wrote down. Here are the settings I am using now but do not seem correct. Resin tank - 12" x 53" Head - bnt5650f head (Independent Water Tech/ Canature) Hardness level is 20 I used this -...

Hello, I have an Independent Water Tech (IWT) 565 (http://www.watersoftenerdr.com/images/565_IWT_Manual_-_Valve_Ver_9.pdf) . Below is the info. 4 adults and 2 big dogs household Municipal Water Location = Phoenix, AZ 1 resin tank = 12" x 52" Brine tank = 14"x 14”x 32" ¾” plumbing I use the...

According to this page - http://www.qualitywaterassociates.com/softeners/sizingchart.htm and the plumbing code constant SFR gpm sizing requirements on the internal link (http://www.qualitywaterassociates.com/pdf/3639_plumbingcode.pdf), I need a water softener with a flow rate of 22 gallons per...

Hi – I recently purchased a new toilet (a complete toilet), brought it home and went to install it. The issue is when I went to install it, it appears there is not enough room to install it – the closet flange is too close to the wall. I am not familiar with solutions on this, but it...

Hi – I recently purchased a new toilet (a complete toilet), brought it home and went to install it. The issue is when I went to install it, it appears there is not enough room to install it – the closet flange is too close to the wall. I am not familiar with solutions on this, but it...

Hi – I recently purchased a new toilet (a complete toilet), brought it home and went to install it. The issue is when I went to install it, it appears there is not enough room to install it – the closet flange is too close to the wall. I am not familiar with solutions on this, but it...