Search results

I have a full spool of solder that's been in the garage for I don't know how long. it is Dutch Boy and has the following markings: Sn 95% Sb 5% also says ASTM B-32. I also have a half spool of one that is Oatey silver lead free solder but has no other markings. I am soldering some...

new construction. no copper in yet. crude sketch of house. i am getting ready to do copper water supply and am unsure on sizing. i have drawn dark blue for 3/4" and light blue for 1/2"( cold water). am i sizing this correctly? i have not included the hot water because i was told to...

gentlemen, a question for your expertise. i have two vents up to the ceiling/attic floor represented by the two red lines in the picture. i have drawn three proposed spots to take it through the roof: A the green lines; B the blue lines and C the orange lines. is there a preferred spot...

1st floor plumb layout revised would like some thoughts on the proposed layout..

so the power is flickering this morning and i went outside after checking service panel. the meter socket ( old round kind) is making sizzling sound and its fogged up inside. so im thinking the socket has water in it, which would make sense cause the wire is terribly old and has almost no...

i posted last week with sketches. i went ahead and DRY fitted the pipes for better image. i am under irc code. is there anything here that is not legal under that code or that will not work properly? your time and thoughts are appreciated.....a couple of notes... 1) nothing is glued. 2) the...

ok. im looking to rough in the basement plumbing so i can get my floor poured. can you pro's look over this mess and see if this will work. i forgot to include the vent for the floor drain. maybe i can just tie into washer drain? i've included a pic of plumbing and also a floor plan so as to...