Search results

  1. kgphoto

    Will bent 3/4 copper pipe laterals pose a problem or can they be straightened?

    A "contractor" put a bunch of copper pipes up in the attic preparatory to re- piping a house. In order to get them up in the attic, he bent them approx 10 degrees off each side of center for about 20 degrees total. So now it is impossible to make a straight run. Can these be straightened by a...
  2. kgphoto

    Kitchen sink P-Trap location question.

    Due to layout changes, that happened before I was asked to get involved, the stub out for the kitchen drain is 24 inches to the side and 13.5 inches lower than the center of the sink drain hole. So my question is, should I attach the p-trap at the wall and then go over to the sink (at 1/4...
Top
✖
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks