Search results

Installer suggested Bryant model 925s. We had 3 estimates from different installers and the first one sold Trane the second sold Carrier and third Bryant. I work nights and am going to have to get to sleep. I will get back with you tomorrow. Thanks

Thinking of purchasing A Bryant Furnace, any feedback on this would be appreciated. Thanks:confused:

Good Morning, Thinking of replacing a Luxaire Furnace within the next few months in our home, what brand would all of the HVAC pros on here encourage their customers to buy? Thanks

Had the HVAC Repairman come yesterday and everything checked out fine with the Diagnosis being [vent motor clogged up with stink bugs] We have had alot of them in WV and he said he had done the same thing the day before on another customers furnace. I guess since the weather has started to cool...

Induced draft blower is working. Would the spiral igniter have an ohm reading stamped on it? 284 is what i am showing.

None of the rollout limit switches are tripped. There were 3 of them. All had 27-28 volts on each side.

Took an Ohm reading and showing 284 and have 112v at the plug in.

What should i get for an ohm reading to determine a bad one?

This is a gas furnace. How do I check the spiral glow igniter?

Just turned furnace on for the year for heat and it will not work. Worked fine at the end of winter. Cleaned the flame sensor as I do every year and nothing. Igniter will not glow. Any suggestions? Thanks

The Electrician came over Monday and one of the dead outlets had a bad connection. The connection was taped up and seemed like it was tight and even the Electrician after untaping the connection said it looked tight but only after pulling on the wires did he discover it was not wrapped as tight...

This is in an Apartment. Tenant had portable A/C unit plugged in and quit working but the A/C unit works in other receptacles and A/C unit is meant to be used on 120v and works fine.Everything else in the Apt works fine except fot the 3 receptacles.

No recently installed gfci.

I have 3 electrical outlets that suddenly quit working in the living room.Checked breaker and it was not tripped and then manually tripped breaker and reset and still no power to outlets.Any suggestions as to what I should be looking for or where to start looking.Thanks

I have one small bedroom with radiant ceiling heat that does not seem to be working. The thermostat is a manual type 240 volt. I am wondering if the thermostat is bad and how I should check it. I have some electrical knowledge and test meters but not sure about testing a manual thermostat. I...

I want to change the valve on the water supply line to a ball valve. There is not alot of room in the existing opening probably about 12in square plastic panel anyway the valve thats in there is soldered and I cant move the pipes up or down in order to heat the valve up to remove it. I was...

Good Morning, and Happy 4th, I have a leaky main shut off water valve in the house that I would like to replace with a 1/4 turn ball valve and would like to install it in a way that if it would have to be replaced I could unsrew it and remove without any soldering so should I use a union on one...

Is it against code in WV to paint the breaker box cover any other color than what it is such as the same color as the room that its in? Thanks

The situation was my 82-year-old father had made all the changes, switching the elements and thermostats and a leaky pressure relief valve before I was involved or made aware. My parents live 75 minutes away and my occupation as a truck driver forces me to only visit them on the weekend...

My parents are having trouble with their Bradford White water htr. At first the bottom element went out. They had it fixed then a couple of weeks later the other element went out and was replaced then a week later no hot water again so the top and bottom thermostats were replaced and they only...