Search results

I converted my dual control water shower valves to a single control. It is a Moen (moen63170)rough in 4 port with stops. The problem is, after I have hooked up all the connections, I get no water flow out of tub spout or the shower arm. I have played around with the stops by opening and closing...

I have an old inline whole house pressure regulator. My city water pressure is around 85 pounds. I have tried to adjust the regulator with a gauge attached right after the regulator with no change in pressure at gauge. 2 questions......the regulator is about 20 years old....is it possible that...

I was wondering if anyone has any info that a water softener caused a hot water tank to prematurely fail? I have had to replace my hot tanks (I have 2)3 times in the last 10 years. I am on normal city water. Someone told me, that if I remove the anod rod in my hot water tank, that will solve the...

My water pump on my boiler is making noise. I was going to change it out. It is an American Standard with a Gossit pump. On the zone manifold there are drain valves. Before changing pump, I was going to shut off water supply to the boiler, then open up drain valves to relieve the pressure and...

My water pump on my boiler is making noise. I was going to change it out. It is an American Standard with a Gossit pump. On the zone manifold there are drain valves. Before changing pump, I was going to shut off water supply to the boiler, then open up drain valves to relieve the pressure and...

Is there a in-line filter to put in after the pump to eliminate calcium buildup? This is destroying coffee makers and is plugging up my washer. Any advise?

I am installing some laminate flooring. Should you start at the entry doorway & lay the boards parallel with the entry way or follow the wall line? Should you stagger the joints, or keep them the same all the way accross the room? What holds the beginning boards so they don't drift off center? I...

Good morning. I am redoing all of my water supply with pex. I have an upstairs area that I am going to turn into an apartment for my mother. I was planning on running 3/4 pex up there, and cap it untill I am ready to redo that area. My water pressure is close to 70lbs. I was going to run a...

I am putting in some new plumbing, and I have to put an expansion tank in. My questions are do I need one for my hot water tank, and the main water supply, or just my main water supply? Where do I mount it, right after the water meter? If I need one for the hot water tank as well, do I mount it...

I am putting in some new 3" sche 40 drain pipe for a toilet, and I was told to use the purple primer before I glue the pieces together. Why do I need to do this, and do I apply the primer to both joints?

i have installed a back-up water sump from home depot, and it is not keeping up with the water coming into the sump hole. i have installed 3/4 pipe right off the main 3/4 line. a local dealer carries the guardian pump by aymcdonald, whcih i am leaning towards, but it is 3 times the price, and i...

Why is it necessary to use primer when gluing PVC joints? Wouldn't glue alone be enough?

i instaling an under-the-counter dishwasher for someone, and the dishwasher is not right next to the sink. she is currently using a portable one. my question's are, if i run a drain line down to tie into either the main stack coming down from upstairs bathroom, or the drain line coming down from...

I recently drained my hot water tank, and while I was doing that, I had to reroute some plumbing, to make it easier to get at my furnace. After I got plumbing done, and water back into tank, every time hot water is used, and as it is heating up, it starts making poping sound inside tank. It only...

I am doing a basement remodel, and the owners have decided they want to put a bathrrom in. They have 2, 4" stacks coming into floor, at opposite ends of basement, and I am assuming that they tie into each other before going to street. I have done just about every other type of plumbing, but...