Search results

Haven’t forgotten about you - been taking care of a sick grandpa this weekend and wasn’t able to do any framing/plumbing but hopeful tomorrow will work out. Was able to check some of the pipes below slab and will draw them up tonight. Thanks again!

I believe the toilets and the entire drain line is vented by the 2” vertical stack I’ve previously called the shower vent. The 3” stack ties into a threaded flange and transitions to cast iron. That stack services 2 toilets and a sink. The floor is concrete and the drain is buried about 6-8”...

Supplies ordered and picking up the rest before the weekend. I’ll be making the changes and routes you recommended - thank you so much. It’s also looking like I’m going to have to rework a lot more of the existing piping than expected. I’m installing a 3 wall Maax Utile shower system and after...

You’re right - it is on its back. To clarify, you’re talking about a combo wye on the left, but the elbow on the right is fine; no need to wash the right? Also - I’ve taken a closer look at the existing washer standpipe trap and is going to be a bear to remove the drains vertical san tee since...

Thanks so much for the quick reply and sorry for the confusion - it made sense to me after proofing a dozen times but this has given me tunnel vision. My question was, should I tie my washer‘s vent into the horizontal 1.5” vents on the left side of the pics that feeds into the vertical 2”...

Good morning, gentleman. Found some termite damage, and a leaky shower curb and one thing lead to another and I’m now remodeling the 1st floor guest bathroom and laundry room on my tri-level home built in 1976-ish. I figured since I had the bathroom walls were opened up I would move my...