Search results

  1. Hube

    Moen bathroom faucet cartridge replacing

    Our bathroom basin faucet knob is very hard {sticky} to pull up. There is a "cartridge" inside that can be removed and either replaced or cleaned of any gook accumulation. I have had no experience with these cartridges, so I'm asking whether its worth trying to replace or clean this cartridge...
  2. Hube

    black specks in water filter

    i have a 150' drilled well, located approx 50' from the house. The supply line runs to the inside,(basement) and enters the pressure tank and then goes to the filter.and then to the softener and then to the other areas of the home,etc.. it seems that this filter {rainfresh type} is always...
  3. Hube

    Thread sealing... pipe or dope?

    After making the connection to my house water filter, I noticed a very small leak where the 3/4" threaded plastic(mip) adaptor fitting goes into the filters' housing. I unscrewed it, and removed the old teflon tape and applied new tape, wrapped tightly about 3 times around the threads and...
  4. Hube

    "sticky" check valve

    Do any of you "pro's" know what causes a checkvalve to make a 'thump-wham' sound when the pump comes on. This is a check valve located near the pressure tank that is supplied by a sub pump in a deep well. It's a 1" brass check valve, it operates quietly for a few months ,but eventually upon...
  5. Hube

    Check Valve noise

    It seems to me when I replace a check valve in some systems,(especially my own) the valve remains quiet when being activated for a couple of years and then starts making a bang or thump noise when the pump starts up. I have tried various reliable brands of brass type valves and seem to...
  6. Hube

    T & P valve disharge pipe into laundry tub

    Hot Water tank is in finished basement level. I.m always thinking..'what if the tp valve blew' So i.m thinking of running it about 10' of pipe ( plus 1 elbow) or so over into the laundry tub, then if for some reason it blows off it won't flood my basement floor (carpetting etc.) Is there...
  7. Hube

    Moen Posi-temp volume

    I have a Moen posi-temp in a shower enclosure. It controls the water temp just fine. Its valve lever is either on or off. I would like to lessen the amount of water by about half. Is this,(as I have heard) not wise because it may damage the cartridge. ? I am considering installing adjusting...
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks