Search results

Thanks for pointing out the mistake, Jeff. I now have a much better understanding of the requirements to use certain fittings for a drain, and also how the snaking ability is restricted with my drain (thanks, Terry!) . Unfortunately, the repair now would require opening up the ceiling again...

I forgot to mention. I replaced the sanitary tee with the fitting pictured below, with the downward sweep facing the tub drain. Will this work? With this setup there is only half an inch of horizontal flow in the water due the the space of the glued section, before it starts flowing down. May be...

Thank you all for your replies. The instructions don't mention screws. I contacted the manufacturer and they said it's ok to use screws. The tub is now installed with screws drilled into the flange, although I had to resolve a couple of other unrelated issues. During dry fit the tub was...

Hi All, I'm installing a Signature Hardware sitka bathtub 60x30 in a three wall alcove. The tub is an acrylic bathtub with fiberglass coating, and has 5 foam feets under chipboard attached to tub's bottom. I'll have stringers on the long side and one of the short side of the tub, but they are...