Search results

I want to use a 1 inch sharkbite elbow to receive a 1 inch copper pipe coming down from a hot water cast iron radiator. I want to do this because the floor linoleum is crappy and will need to be replaced. I want to make it easier to move the radiator out of the way. I got a better tube cutter...

I never sweated copper street elbows before. I fit them together and there seems to be some wiggle room. More than with a normal pipe and fitting. Will this fitting with the smaller diameter of the street elbow inside the normal pipe solder OK?

So .... I found a free cast iron radiator on local craigslist, for free. 19 in high, 13 in wide, and5 1/3 feet long. I hired 2 movers who arrived on site and learned they could not move it. I did not have to pay. Lesson learned. I recently found one cheap on craigslist and do not know the exact...

When I go to Home Depot I recall seeing black pipe, galv iron, and galv steel piping. What should I use to pipe in cast iron radiators?

I have a hot water cast iron radiator system. It has separate supply and return pipes. My kitchen had slant fins that never got warm. I do not want to rehash that issue. The kitchen had not seen heat since at least before 1998 I recently learned. In a desperation to troubleshoot I cut the 3/4...