Search results

Thx for responding... yes its a p trap. It's only about 1/8 inch gouge. Looks bigger for some reason in the picture. It could be changed out by taking out some sheetrock below. I know thats what would be recommended I was hoping that since theres a good amount of room to glue and grab the...

Hi, I had to remove a piece of PVC from an old shower flange during remodel and as you can see in the picture I was successful except for a small piece that cracked off. I need to insert a small piece of pipe to extend for the drain. Is this Ok to just re glue and install the PVC pipe? I...

Thanks for all the answers... appreciate it. I'm gonna take some drywall out to see what I can do.

Thanks.. That would make sense but I ran the hot water in the master sink to a bucket actually 2 home depot buckets so a decent amount of water and no sound. Ran the sink in the other shower after and heard the ticking sound. Could it be expansion contraction of the PVC drain?

Thanks... So the master shares a wall with another bathroom that has a tub and it the noise happens when the tub is filling or showering. The noise only happens when I leave the water on in the master bath sink. It doesn't happen when taking a shower in master bath for some reason. Not sure...

I have a ticking sound in my walls when the hot water is on I’m doing a bathroom reno of my master bath and I want to see if I can fix it. I’m not sure whether to go up through the ceiling below or to pull out the subfloor in the area I need to check in the master bath. It’s right by the toilet...

I am installing a Panasonic fan in a master bath. There is attic access but there is blown in insulation in the attic walls and rafters so access is difficult. i would like to go directly out the side of the house as its only a few feet to run the venting. It's a 4 inch flexible duct but...

Thanks Terry.. Ok so if I put the shutoff valve at that level you're just saying that the supply hoses are different lengths to reach. I wasnt sure if there was a code issue with the length of hose to the sink fixture although I do understand that washing machine hoses are much longer. I'm a...

I have a weird drain configuration and the water supply lines that come up through the wall can only come up about 12 inches from the base before hitting the drain PVC. I need to do the stub out at that height. Is it ok to be that low.