Search results

Thanks!

Thanks!

I need to add ball shutoff valves to my bathtub. Is there one brand that is better than the rest? Thanks!

Thanks!

Any pipe dope?

Thanks!

One of the tank bolts is leaking on my 10 year old Drake toilet. I’ve ordered a new tank seal and new tank bolts. When I installed this ten years ago I remember the tank gasket didn’t want to compress all the way. The tank would always shake a little. When the tank bolts are fully tightened...

I need to replace the cartridge in a Delta 1700 series shower control. I've heard that the cartridges can be difficult to remove. They make a 1300/1400 cartridge puller, but it doesn't say it will work on a 1700. Do they make one for the 1700 series? Thanks!

Yes, it would kinda hokey. I guess a quick partial fill every couple of hours will have to do.

My house was replumbed in the attic. The washer is on an outside wall. The pipes have foam insulation and about 18” of blown insulation on top. I just need a way to drip the faucets when not in use, but still be able to wash clothes when needed. Repeatedly disconnecting and reconnecting the...

We are going through about a week of 5 degree or less temperatures. I have the heat turned up, space heaters running, and faucets dripping. But my cold water line to my washing machine keeps freezing. Is there a way to hook up the water lines so I could drip them? I don’t want to have to keep...

Everything from the wall, to that first down elbo is glued. I’d rather not redo that if I don’t have to.

It’s leaking because the gaskets need to be replaced. But the main thing is the p trap is backwards.

I unclogged my sink today. The blockage was a little past the wall. The fittings are old, and won’t seal now. And the p trap is backwards. Can anyone tell me the correct fittings to connect from the end of the glued pvc fitting to the sink down pipe so I can get the p trap going in the right...

Basic question, but can you recommend a quality washing machine supply hose? Thanks!

Fixing a sprinkler system made of PVC. I purchased some Oate CPVC glue instead of PVC. The can says it works on both, but the glue was kinda lumpy. The lumps seemed to go away when I stirred it. Is the CPVC glue ok for PVC? Thanks!

I'm getting ready to install an NDS Slip joint pipe repair part in my sprinkler system. Is there a flow direction for the part, or can it be installed either way? Thanks!

I did a search on washing machine supply lines, but didn't get any good results. I know I need the stainless braided hoses, but which ones? The reviews are all over the place. Thanks!

I have an expansion tank on the hot water tank. Is it worth the expense to have a pressure regulator added out by the city water meter? I think it would be about $350.

Thanks Terry! Is that the brand you recommend?