Search results

Final step to the plumbing of my never ending project.... I searched for this found nothing.. I don't see anything under upc that would keep this from working... let me know what you all think. :) So I am adding a sink out side... the pipe under the exterior slab will be 2 inch. I plan on...

If the basement has drywall.. First thing I would do is cut a hole in the cieling directly under the shower and inspect..

Terry I absolutely appreciate all the help. Also I would like to clarify horizontal wet venting. Is 12 ft the limit for 3 inch pipe at 1/4 slope? I ran 3 inch to vanity assuming 6 ft was the limit for 2 inch.

This is what it looks like The 3x3x2 wye is for a shower trap. the distance from vanity to 3x3x3 wye is under 9 horizontal feet. Also the 2inch wye is for a clean out. Which will be in vanity cabinet. Hopefully this clarifies what my question was about horizontal wet vent and the wye fittings...

Also my diagram represents all horizontal layout. All with in 10 inch floor joist sorry my diagram is not drawn to represent that.

So I take it my layout will work? I started putting everything together. I hope.. I don't have to start over haha. I am using all wye fittings with 45s to angle where I want. All my wye fittings (2) are almost laying flat.. not rolled up. Also I have just under 9 foot total horizontal wet vent...

Will this diagram work? Wet vent bathroom group. Also do any of the wye fittings need to be rolled to a 45 or greater angle past the pipes center line. Or can they lay flat/horizontal. I looked at code and to my understanding they can lay flat and this would be a legal horizontal wet vent...

Also can my 3x3x3 wye be installed flat or must it be a installed at a 45 degree angle?

Hi Terry, as always thanks for the reply. Unfortunately thanks to the wife haha... that layout is no longer valid for what I'm needing. And the deeper I got into demo plans changed. First off I decided that we can do with out a steam generator. Also I have a new layout with a long stretch of...

Finally doing a bathroom remodel. Moving a vanity and adding a steam generator. I understand it will need a drain/ptrap. Will my plumbing diagram work? The steam generator will be in the vanity so my idea is to come up through the floor and bottom of cabinet with a 2 inch stand pipe. Thank you...

finally doing my kitchen remodel.... trying to figure out kitchen sink venting. I have a window 14 ft long and it sits 40 inches from floor to bottom of window. Sink is located smack center 7ft. Don't know what to do about the vent. Too low to run accross... it's exterior wall so I'm told I...

Could be thermocoupler. Or an obstruction in flue causing it to get to get too hot and shutting it down. Does the red reset buton pop out when it shuts off?

Good to hear you got it sorted out

Does your water heater have the cap as seen in picture. The cap where the vent pipe would attach to.

Does your handle turn counter clock wise?

Thanks I appreciate the reply. 99% of me knew the answer the 1 percent was hoping I wouldn't need to open up concrete. Thanks So much

Can I add a kitchen sink drain to a 2 inch bathtub vent. The vent is exactly center to where the kitchen sink drain should be. the 2 inch vent goes through the roof. i know i can wet vent bathroom group.