Search results

Thank you for the info Bannerman... 8am actually works for us because we are up and already out of the house by then. We normally run our dishwasher after 10pm and do Laundry around 8pm. There is nothing running inside the house that would require water at that time (weekdays). I wish I could do...

It's the back wash that is very noisy. It sounds just like this video . My Water softener is about 4 feet away from the wall being shared with kids bedroom. At 2am you can hear it even more so

I have changed it to 2:00 but I think I will change it back to 8am because it's freaking noisy and my kids bedroom is sharing wall with garage where my softener is and they get scared with the noise :-). I am planing to regenerate every 14 days and will adjust it to one of the week days when we...

Yes... Salt is above the water... I will poke the button tonight and will see what tomorrow brings :-), actually, I wont be home tomorrow until Sunday but I will report back on progress. Thank you for your quick response :-)

I have purchased a "Hach 5B Total Hardness Test Kit" and just checked today, it took 20 drops of "Hardness 3 Titrant solution" to turn my water to blue... This means my water is equal to 342 ppm. Water Sample was taken from outside faucet (not connected to my softener). In the meantime, while...

Thank you Bannerman and Reach4 for taking your time and be so specific. I am going to give it a try and report back in few days with my results :-)

Thank you for taking time to look at this post and provide all the info. For the test kit, I have purchased one from HW Department Store (Lowes). Here is the link to the one I used. https://www.lowes.com/pd/Mosser-Lee-H2O-OK-Drinking-Water-Test-Kit/50352996 If you look at the last picture, my...

Thank you for the info... It doesn't hurt to run extra few regeneration's to see if that would fix the issue :-)

Yes... System was offline for few months when I noticed that is not working 100%. Then after the brine tank was cleaned, I have set it back online/ in Service mode. I still see the same thing as before. Some Hardens is taken but not completely. Now I am just assuming that it could be related to...

Not sure what to do... I have Fleck 7000 unit. I have noticed for some time now that my water is not right but didn't have time to check on this. Finally this weekend I cleaned up brine tank, added salt and took water sample while in in bypass mode. The hardens was showing as 250. Did...