Search results

I did get a decent fix done, I don't think I'll ever use the bath tub more than 5 times ever, and I would mostly use the tub faucets to fill a bucket or wash out a ice cooler. And I did decide to use a 1/2 in. FIP x 1/2 in. FIP x 20 in. braided supply line, along with a Sharkbite 1/2" brass...

If you read each post, then you would've come across the part where I said this The white pipe is a shower tension caddy similar to this I'm basically looking to replace the spouts only and need to figure a way to make the transfer from 1/2" copper to whatever the attachment is for the...

Yeah, after thinking about it more and researching, I may have to cut the pipe down for a rough-in kit (if i use one) anyway, which would help with moving the joint down away from being next to the horizontal 2x4. The valves are wall mounted to the left, Hot - Shower - Cold, those are fine, no...

I recently purchased a condo (first time home buyer) and it wasn't till later i found this problem. There is a small section of either (3/4" or 1") galv pipe or regular steel used to attach the faucets (two, one on either side) to the 1/2" copper plumbing coming from the wall. One is completely...