Search results

Update - P3002-150 is the correct part. Fits perfectly! Thanks @Reach4 for the tip. Here's a dry fit image:

Alas, I have confirmed that Alas, I have confirmed the 3001-150 (reduced) opening is too big for the brass tailpiece. Need to investigate the P3002-150.

Thanks. It appears there is a 1-1/2 to 1-1/4 no hub coupler I could install, assuming the brass tailpiece is 1-1/4:

Hello, I'm installing a stone resin (heavy!) freestanding tub and to simplify things, would like to just drop the 1-1/2" x 8" brass tailpiece into a hub trap glued into a (glued) trap assembly. Something is making me pause on this, as the ceiling will be sheetrocked and this install will be...

Ah good points on alignment, etc. Thanks for your help! Cheers, FLN

Your #1 could be my option - drill a new hole (will be about 3-4 inches from existing hole), use a single 90 long elbow - note the trap would have to be parallel to the joist - it's not clear why I should avoid this orientation, since this is the exact location where the 1 1/2 drain will come...

Thanks for the reply. I could certainly do two 45s if I drilled the joist at an angle. Wasn't sure if code would allow 45 degree hole in joist? The vent is within about 16 inches of the first 90. The trap is about 6 inches from the second 90. The joists are 2x10. Hole is < 1/3 of the width...

Hello, I've been a long time lurker on this most excellent forum - so much great advice! I'm in the throes of a master bath remodel, replacing one of those old built-in whirlpool units with a freestanding tub. This required me to move my 1 1/2 tub drain line over one joist space. Due to...