Search results

I saw that as well. I didnt really understand where to hit and what that was really going to do. If I do get this out is there going to be a foot valve at the bottom? sounds like it might have a point, do points have check valves? do you replace the point or a check valve further up? Im...

I would agree the car jack should be able to lift more but the issue I think I was havin was I could not lift straight. Which caused problems. I will try the car jack again pushing down on the outer case. I’ll have to think how that one is going to happen. I only had one pipe wrench big enough...

So I didn’t completely follow the last part. What did you mean by pulling the inside against the outside. The car jack I put a board under my t handle that I made. And jacked up one side of the handle as close to the center as I could get. I could not get the cap off, when I tried the whole pipe...

Cap says as best I can. Is pat 2657?833? Can pat 500284. Sak?? Mfg co Evansville wis. Maneto ??? Maybe in the middle. Really hard to read.

Reach4 thanks for that link looks like my well is 39 to 44’deep. It calls out a 2” casing though that doesn’t seem to be what I have is it? Says pitless adapter. I took a screenshot but was too large to post. Says the static water level is 23’. Done in 1978 if that helps at all.

Cleaned it out it is full with metal not what I was expecting but I don’t think this is a standard pitless? Do I have to try and remove that outer ring that looks lighter color in the picture possibly? It looks like it might possibly unscrew? Also I may of been wrong as the outside is only...

I will try to put some air in there tonight but it feels like the casing is full all around the pitless. Maybe it is just sand? I will update with pictures when I get home.

So tonight I made a t removal tool and tried to pull it out. Any trick to it? I tried pulling no movement. Tried a car jack nothing. Tried good ol brute force with a hammer and it doesn’t seem to move at all. Any idea how much force should be required. Was thinking a chain hoist might work...

Hello all, I have decided to embark on replacing my well foot valve. Ever since I have bought the house If I lose power I lose the prime on my pump I usually just hook up to the neighbors house and refill my whole house system to reprime my pump, as I have tried the pour water in the pump but...