Search results

Hello everyone from LA CA What is the minimal clearance I can have an eaton transformer away from an ice maker in a commercial kitchen? Thanks.

Anyone in CA with an affordable short term insurance company also any good bond places for a plumbing business? thanks.

Figured thank you sir never did much but given it's half the house you are right, a reroute is in order. Half the house is effected indicating it's mainline hot side . Had to wonder what it entailed and if it was worth it. Ty bud Josh - California

Hi everyone, I keep hearing about a "blow-back" aka galvanized system flush when the pressure gets too low and to rid it of rust clogging. I'm so swamped and the lines are in slab. Before I consider a reroute, anyone know how to properly perform this old-school style service? The cold is good...

There is enough capacity to add the grill but I'm worried about a pressure drop or the tankless failing to light. I was going to maybe reconfigure the drip leg and add another tee (3/4" x 1/2") for the grill. Does anyone know if this could be possible? The main is very hard to reach. Kinda hacky...

Hi, what state ate you in and what ended up happening? I have the same dilemma. I think I'm going to play it safe and put it above. Thanks

Thanks guys, I'm going to grab an ABS fitting saver and drill it out to 2 inch. That way it doesn't back up and I have piece of mind. Appreciate the help as usual brothers!

So in the wall and under slab tying into 3"main should be fine on 1-1/2"?

Is an 1-1/2" lavatory drain running vertical to horizontal allowed over _ft? Or should it be 2" with a reducing san-tee for vent and stub out? Thanks, Josh from CA

Why does this have two gas supply lines I forgot what the tee is for at the top always appreciated thanks Watts 210

Yes, I'll take the details as far as precharge and size

Hello to whoever can help me. I'm trying to stop a noise issue in a busy 20 unit salon located in a mall. Every time a Sloan toilet is flushed (3 of them) there is a loud water hammer bang in the ceiling near the commercial cyclone heater. I've installed arrestors on the riser 90s in the drop...