Search results

Gotvto the property this morning, put a ball valve in line and cracked it open and turned on breaker. Pump still cycled as before. I watched water level in pipe and it stayed the same when pump was off or on. The breaker box had a 30 amp 230v breaker in it that was labeled well. Amp clamp...

No pressure tank and no pressure switch. Wiring directly from the breaker to the casing wiring. I will run out to the property tomorrow with a ball valve and reduce the gpm to see if that makes a difference.

It's a 2 wire 220 system. The wiring from the pump is your two 220 legs and a ground. The power came from a pole mounted circuit box that fed the house and well. That not damage/affected by the fire. I just ran tree 10 gauge wires from the well wiring to the circuit panel and attached it to...

My Son bought a property where the house had burned down. The well has a 4" casing, the static water level is 22 feet and we believe the depth of the well is 75'. He finally got power to the site and we decided to test his well pump by direct wiring it to a breaker. When we switched on the...