Search results

I'm in Canada so that complicate things lol Yeah I've seen this, if the flow is too low, I'll drill out the cartridge I guess I don't want a diverter on the tub spout, the R10000 will only have a single outlet going to the R11000, other outlet will be capped. My plan is handheld, overhead...

Yeah I did look into using FNPT adapter to 3/4" PEX but that and the drop ear you linked to but they are not readily available, I may as well just sweat it, done a few soldering jobs and none leaked yet, just afraid to mess up an relatively expensive valves lol

The tub will be connected to one of 3 outlets on the R11000, what Delta do not recommend is using the diverter valve on a tub filler spout. Moen M-Core transfer valve? Moen actually lets you use their transfer valve with a tub as opposed to Delta and it's rated for 6GPM iirc. I was also...

Delta do not recommend this setup due to flow reduction but I hate tub spout diverter. Because of the restriction in the cartridge plus the diverter valve (5GPM?) is it worth connecting the spout with copper or can I just use 1/2" PEX? I do like the 3 screws PEX drop ear, they are nicer smooth...

Yeah I thought about the same thing and replaced it with a long sweep

Spent half a day visiting local plumbing supply stores to locate a direct drain shoe/tee, finally found the holy gem. Got it all dry fitted but wondering if I should use a long sweep for vertical to horizontal transition or does it not matter for the overflow?

Currently have 4" cast iron stack, from WC, it's connected to an elbow, followed by two 4x4x2 wyes that connects the kitchen sink and the bath/lav, another elbow and goes vertical into the 4" abs stub that goes into the bench footing (main horizontal drain that goes to municipality's sewer)...