Search results

Hi, I took apart this drain (on a Bain Ultra air tub) to clean some hairs. When I put it back, it leaked under the tub because water got underneath the thin black rubber seal. It could very well be because I didn't tighten the drain down well enough to squeeze the rubber against the tub...

Hi, Such awesome and knowledgeable people here! Thanks for sharing your wealth of info. I have this kitchen sink in an island that has frequent problems with slow drainage and loud gurgling. I've ignored it for a long time but recently tried to address it. I started by replacing the old...

Thank you! I'd prefer to keep the spout I have. So I carefully removed the adapter (see pic). I'm hoping I can just get a brass coupling and nipple to extend it to around 4 inches, then use the spout without it's plastic internals.

Hi Folks, I am trying to replace an old tub spout (in the pic, on the right) with one from a new oil rubbed bronze trim kit. But the old one used the brass adapter - which seems to be threaded on to a copper adapter which is soldered to the copper stub (is that right?). Do they sell a...

Hi, I have the shower/tub setup pictured below which I'd like to replace with a new trim kit from Delta. Am I correct in assuming this is an old style valve? Will I need to replace the valve with the new rough-in? Or will the new cartridge work with the old valve body? Here is the new Delta...