Search results

  1. Rfsmith48

    Whirlpool fridge repair: icemaker

    Thanks guys! The PartSelect website had the schematic I needed. A Utube search using the Model # got me to a good tutorial. I just ordered the part. I will report back after the install. Thanks Again! Rog
  2. Rfsmith48

    Whirlpool fridge repair: icemaker

    Folks, Thanks for the responses. The fridge is about 5 years old. It's a side-by-side, with the freezer on the left. The icecube tray has a sensor (poorly) attached to the bottom of the tray. I am guessing that the senser is some sort of temp sensor. The sensor is held in place by 2 molded loops...
  3. Rfsmith48

    Appliance repair: Whirlpool Fridge

    Hey, I am looking for an internet resource for appliance repair. Google wasn't much help. This website has always been a source for useful knowledge! Any help is appreciated. Thx, Rog Smith
  4. Rfsmith48

    TERRY LOVE CELEBRATION OF LIFE

    Folks, Terry Love and this forum has helped me so many times over the previous 10+ years. My sympathy and condolences to the family. Does Terry, or the family, have a preferred charity? I would like to make a donation. Thanks, Rog Smith rfsmith48@gmail.com
  5. Rfsmith48

    Kneepad recommendations......

    A little bit of everything. This week I resealed a toilet. I graded, ground clothed and planted a small garden, etc. BTW: I am 74 and both knees have been replaced. I am looking for specific products and recommendations. Thanks! Rog
  6. Rfsmith48

    Kneepad recommendations......

    Hey, I need a recommendation for kneepads. The ones I have now are sloppy/stretched out, and the Velcro is tired. I am 6 foot, about 220 pounds. Thanks for the help! Rog
  7. Rfsmith48

    Honeywell thermostat function/comparison charts.....

    The furnace is a Lennox SL280UHV. Install instructions state: "...is compatible with any Lennox communicating thermostat. Or, Non-communicating thermostats - ComfortSense or other conventional thermostats." Not a lot of help (For me). I would like to use a Honeywell WIFI tstat. Thanks, Rog
  8. Rfsmith48

    Honeywell thermostat function/comparison charts.....

    Folks, We just had a new Lennox furnace installed. It has a 2 speed fan. The fan necessitated a thermostat upgrade for the new fan system. Previous Tstat: RTH8580WF1007: WIFI thermostat that I installed about 6 years ago. New Tstat: T6 Pro Thermostat: Programmable. I would like to replace the...
  9. Rfsmith48

    Heat pump HVAC in Colorado?

    Hey Taylorjm, Thanks for the response. What is the furnace rating that addresses the ability of the furnace to support the square footage of a house? Our house is about 1800 sq ft. And is there a "rule of thumb" that is useful for comparing the furnace blower rating to the house size? Thanks...
  10. Rfsmith48

    Heat pump HVAC in Colorado?

    Thanks, will do. Rog
  11. Rfsmith48

    Heat pump HVAC in Colorado?

    Folks: I have a 50 year old house in Boulder CO. With a 50 year old gas furnace.... Heating degree days here are about 5600. The local utility has been promoting heatpump HVAC systems for homes. With rebate incentives. BUT....None of the local contractors I have talked with want to quote...
  12. Rfsmith48

    Burnt residue under pilot light

    Folks, We have a 50 year old Lennox furnace that seems to be working fine. About a week ago, I checked and changed the hammock style air filter. I noticed some charred residue under the pilot light area. I don't remember seeing this condition before. I vacummed out the residue and closed up the...
  13. Rfsmith48

    Limited flow on First zone of Irrigation system

    Hey, Thanks for the response. Two of the blocked spray heads had loaded up the screens. Cleaned them up and everything works well. Thanks again! Rog
  14. Rfsmith48

    Limited flow on First zone of Irrigation system

    Hey, I have a Rainbird system that is about 15 years old. No big problems until this year. The First zone which is mostly pop up heads is not flowing well. It worked fine last year. It behaves like there is a (new) flow restriction somewhere in the zone. Has anyone else seen this sort of...
  15. Rfsmith48

    Cabinet, furniture refinish

    Hey, I am looking for forum suggestions/recommendations for cabinet and furniture refinishing. I suspect that there are (Non Terry Love) forums that are useful for this type of advice. All help is appreciated. Thx, Rog
  16. Rfsmith48

    Ronbow sink: VERY slow overflow drain.....

    Folks, We installed a Ronbow vanity and sink about 5 years ago. Yesterday, we left the water running with the drain closed. The overflow runs at about half the faucet flow. Small flood. The faucets and drains are Kohler. (Not sure the model) I cleaned up the mess and am trying to figure out...
  17. Rfsmith48

    Computer controlled HVAC vents.....

    Folks, Is there another Web Forum with a larger number of HVAC folks? BTW: Not sure what a "Blower door" is. There are no movable parts near the fan on this furnace. Thanks again, Rog
  18. Rfsmith48

    Computer controlled HVAC vents.....

    Hey, I saw a show on "This Old House" (I think) several years ago that demonstrated HVAC vents that were individually controlled via several room controllers working thru the home Wifi. (I couldn't find a web reference to the show.) We have a '70s Bilevel house, and the lower level is COLD...
  19. Rfsmith48

    Disconnecting the hose at the sprinkler head barbed fitting.....

    Hey, I need to tap into an existing circuit to feed water to a small flower garden. The plan is to install a T below an existing head. To do that I need to remove the existing 90 degree fitting and replace it with a T. I would like to avoid shortening the Head hose, or digging it up entirely...
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks