Search results

Had a plumber come out and we actually found a way worse crack on the top of one of the big pipes. As many of you suggested, this design is a mess. I'm going to have the entire area replaced. Based on these photos, how much would you think this should cost for materials and labor? I just want...

I cut about a 1 inch section of pipe out. Was able to get the rubber over without cutting it. Didn't even think about just cutting it in half. I'm a work in progress! Lol.

Did a shielded coupling as a temporary fix. I think I'm going to have a pro come in. Coupling:

Thanks for the response! Here are some better photos of the overall schematic. https://imgur.com/a/QqVmRtB The pipe that is rotting is 2 inch cast iron. So you think I should cut from above the p-trap? Where should I make the next cut? Is replacing with cast iron an option or do I have to...

I'm usually pretty good at handling small DIY projects that pop up. But plumbing, beyond toilet flappers and minor sink repairs, has not been a challenge for me yet. Looks like that is about to change and I am wondering if I can get a little advice! My basement is unfinished except for some...