Search results

  1. Rick D

    Sink drain offset

    Hi guys. Thanks for the replies and sorry for the lack of a better description. I was just going to cut it off leaving at most 3/16 of an inch of 1.5 pipe exposed and then push a female coupler onto it and into the wall. But I thought before I do, let me see if heat would have any...
  2. Rick D

    Sink drain offset

    Saw it off where it attaches to the 1.5” drain pipe coming out of the wall? It’s right up against the wall. Sawing it there would mean I’d have to glue the new female through the wall...which I’ll do if I have to....just didn’t know if there was an alternative
  3. Rick D

    Sink drain offset

    We’re redoing our master-bath and the old 1.5” drain has a glued 90 degree down elbow on it as soon as it comes out of the wall. The new sink drain is a good 10” to the right of this AND 8” or so in front of where it comes out of the wall. It’s the immediate down angle as soon as it comes out...
  4. Rick D

    No ground bar in panel

    Hi all. In my shed I installed a Square D Homeline 100 Amp 6 space 12 circuit indoor surface mount main lug load center with the intent of using my 4500 champion generator to power it given its distance from the house. I use a 4 wire generator extension cord to connect the generator’s 30 amp 4...
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks