Search results

Thank you for the feed back. The hole I'm referring to has a cement bottom. And yes, the WH leak would be my concern. Once I open the valve out of the old WH drain, I'm certain that I'll not be able to close it again. So, as I'm writing this, it occurs to me that a transfer pump connected to a...

I have a hole in my basement floor that is 13" deep x 11" in diameter. There is no sump pump system anywhere in the basement, so I assume that's what this hole is for. This basement has been dry through heavy rains and piles of snow, in the six years I have lived here. This house was built in...

That link is exactly what I was looking at. So, if I add 3/4" line instead of 1/2", it will not pull too much from my furnace? You're right, I should add an extra T or two for possible future connections. Thanks again for your feedback.

Thank you for the replies. Forgot to put in that the furnace is a 75000 btu unit. 20 years old. The tanked water heater I chose, is 40000 btu. I was looking at the pipe table last night but couldn't make sense of it.They were showing the numbers in CFM. Unless I was looking at the wrong table...

Hello everyone Hope someone can answer this. I'm installing a new gas water heater . I'm replacing the current electric water heater. The location of the new heater will be a new location, more equidistant between the two bathrooms in the house. It will be located in a full basement, 50 x 27...