Welcome to Terry Love Plumbing & Remodel DIY & Professional Forum. More »
Separate names with a comma.
Thanks for the response. Two of the blocked spray heads had loaded up the screens. Cleaned them up and everything works well.
I have a Rainbird system that is about 15 years old.
No big problems until this year.
The First zone which is mostly pop up heads is not...
I am looking for forum suggestions/recommendations for cabinet and furniture refinishing.
I suspect that there are (Non Terry Love) forums...
We installed a Ronbow vanity and sink about 5 years ago.
Yesterday, we left the water running with the drain closed. The overflow runs at...
Is there another Web Forum with a larger number of HVAC folks?
BTW: Not sure what a "Blower door" is. There are no movable parts near the...
I saw a show on "This Old House" (I think) several years ago that demonstrated HVAC vents that were individually controlled via several room...
I need to tap into an existing circuit to feed water to a small flower garden.
The plan is to install a T below an existing head. To do...
The bearings themselves seem to be fine. The rubber isolation donut is shot on the drive side, not much better on the opposite side....
I got another interesting problem. (At least to me.)
45 year old Lennox furnace, model G10-165-1.
Furnace and blower run fine, but...
Thanks for the responses.
I did not make the situation as clear as I could have....
This is not a sanitary drain. (No trap)
We have a stairwell off the uphill side of the house. Bottom of the stairwell is about 4 feet below grade.
It has a small iron grate and a...
Hi Sino King,
What is an effective way to measure the airflow across the coil? Pressure drop? (mm of H2o?)
The temp range from inlet to outlet vents is in the 15 to 20 degree range.
Does this temp range indicate that the coil is not icing?...
Not sure if this is the best venue for these questions, and I am looking for website references as well.
I have an older furnace with a...
I am having a Homer Simpson moment.....
We recently installed a new Kohler tub. We did not do enuf test driving in the local...
Thanks for the comments.
I found a good Tstat forum on Yahoo.
To clarify: I understand that the Tstat cannot improve/change the furnace...
Just installed this thermostat. We like it.
The wireless interconnect is nice.
Is there an Internet users group for this device? (Or...
System pressure was marginally too low. Bumped static pressure from 40 to 46 psi. Seems to have fixed the problem.
Thanks to all
Can't find a Consumers reports test/rating for radon testing.
Are any of the DIY tests effective?
Has any organization rated the DIY tests for...