Welcome to Terry Love Plumbing & Remodel DIY & Professional Forum. More ยป
Separate names with a comma.
yes I figured that but there is no master valve connected to the controller at all. I have now located and tested all the solenoid valves. Tested...
There's no master valve connected in the Toro control box. just an empty port. Could it be wired differently? ie using one of the regular valves...
I dont know which station controls which solenoid so that would be a very lengthy process and hit or miss. Today I tried replacing the controller...
I turned the flow on manually through the backflow preventer and all but 1 zone went on but none were responding to the controller ie all on or...
measured the voltages and the resistance on the lines from the controller to the solenoids. all were fine. yesterday I checked the resistance on...
Thanks for everyones suggestions on here! OK so this morning I replaced the rain sensor as they were relatively cheap. No difference. System still...
yes thats the one and I have followed that owners manual but its troubleshooting guide is pretty non-existant. I plan to replace the rain sensor...
[ATTACH] I think the backflow preventers may have been a red herring but did help me figure out it wasn't a water issue. above is the control box...
yes the picture you had on the left is exactly what I found down the third control box. I used a multimeter to test all the solenoids and all...
We have had irrigation working fully for the last 3 years but this season when I turned it on NOTHING.... The Toro Controller says its working but...
