Welcome to Terry Love Plumbing & Remodel DIY & Professional Forum. More »
Separate names with a comma.
You might as well pick up some tubular fittings for a kitchen sink.
They make a 1.5" x 1.25" slip joint washer that converts at the tail piece of...
Normally I see those flashed to the floor there. How to describe? For a non metal-head?
I"m pretty sure they make a flat metal piece for that....
TOTO Washlets come with their own adapter.
The top fits to the 7/8" fill valve and the bottom receives the 7/8" supply line.
In this case the toilet should get it's own vent before entering the main line there. I would consider redoing the piping for the sink while you...
Where I'm at I use M, but places with corrosive water may want L
Any place you have a vent should connect to the capped off vents in the ceiling. If the bar sink has nothing nearby, perhaps an AAV there.
It may be very difficult in Washington State to do tankless electric due to our cold incoming water temperature. However, with a model number we...
The hammer arrestor do fail over time. A lot of the plumbers are setting them up so that a threaded arrestor can be replaced later.
Is that a tag on the supply line to the faucet? You might have to connect the manufacuer for a replacement.
Did you also remove the nylon washer?
Here the easyout has been sawed off at the end so that it works with a 90 bend behind it.
I would stub out four times and use the standard stops. To me that's a cleaner look and makes for easier replacements.
Three of those with have...
Don't forget the clip that holds the spray handle on the hose.
There is never one way to plumb a home. This thread can go on and on and on. But at some point, it will be plumbed, inspected and moved into.
Yes the lav can wet vent the toilet, but it's also a good place for a cleanout. If you having a cleanout there, it hardly matters whether it's...
He's using the lav as a place for the end of line cleanout.
The kitchen sink upstream is why he's not wet venting. It's a combination of bathroom...
Sounds like you and your crew are working hard. :)
45's on the vertical are fine.
Looks like a nice job on the Island vent.
Breaking out the concrete should give you the room then.
We're glad to help. :)
It's very quiet in the Seattle area right now. Even though Washington State was in the news first, we now have 262 deaths which is less than some...