Search results

Ok well thanks for trying I do appreciate it. I just may have to hire that done. I definitely don’t need to burn something out getting over my head. At least I know it is possible to do what I want b

thanks again for your help. Maybe it might help to admit my deficiency. Years ago I worked as a plumber and once in a while when needed did a little on the heating side. What I showed you was very easy for me to do because I had watch and helped install this stuff before. But reading your wiring...

Thanks for your reply. Your wiring diagram is above what I am capable of understanding. I did the wiring in the box of the taco control valve and had no problem with that. Is there a specific relay that I can buy and play with it to figure it out. I noticed you had the fan in your diagram. That...

thanks for your reply. I am sorry I think I am failing with my question. To answer your question right know when the garage zone called for heat and there is power to the bottom screw it it send power to two wires. The first is the water circulation pump and the second is the fan blower motor...

The controller is a Taco SR506-EXP The power comes from the controller box. I might have ask my question incorrectly. I am not sure there is any provision with in the box to start two pumps at the same time. Except of course the main loop circulating pump. That is why I was asking about a...

Thanks for your reply Everything i am dealing with is 120 volts except the thermostat. The taco zone relay pretty much takes care of everything for me. I just need to add a second zone and heater in my garage. I some how need to bring 2 hot wires down to my circulating pump each from separate...

I am trying is future out my options for adding a second heater in my garage for a additional third stall. I currently have a hot water to air exchanger out there. It does a good job but runs non stop when the temp gets to -20 outside. So I am not expecting it to be capable of heating more...