Search results

I am installing a brass wall mount sink and sink and discharge are on center but only 4“ apart horizontal,vertical I have 9to ten inches. the pipes a all visible I am having trouble getting it to line up and look good. It is a under the stairs bathroom.A sink and toilet only and the walls have...

Sorry I just re read it and you are correct very hard to read.

Ok thank you, am I correct in thinking that an holding tank unpressurized on top of the ground 8’ tall and jet pump with one inlet and one outlet the outlet going to pressure tank and switch the holding tank side would not be under pressure only gravity right? the strange thing is if I open tank...

Or is there a check valve inside the first tank there is pvc pipe plumbed into the bottom fitting inside the tank. I can not see exactly what the piping is doing it is at the bottom of the tank.

I added another holding tank 2500 gallons. So the first tank has has a isolation valve on the bottom with 1”1/4 pipe that goes down 20” then up to the pump 15’ away the 2nd tank has isolation valve on the bottom fitting then 1”1/4 down 6” and glued to a tee where I cut the pipe coming up to the...

I just did this hook a second tank up to the pipe right in front of the pressure pump in line with my first tank. I put a shut off valve on the 2nd tank so I can isolate tank if needed. I opened the valve and it is finding level. my problem is when both tanks are open it loses pressure I close...

I just did this hook a second tank up to the pipe right in front of the pressure pump in line with my first tank. I put a shut off valve on the 2nd tank so I can isolate tank if needed. I opened the valve and it is finding level. my problem is when both tanks are open it loses pressure I close...