Search results

The foundation ground water is the easy part... but do i pipe the softener to the septic instead,?

Both pit output lines have check valves on them. Im ok putting the softener water into the septic but again the foundation water seems like way more stress on the septic than necessary. I've got in ground sprinklers and really the prospect of a drywell and backhoe digging isn't a appealing...

Hi all, I bought my home in June this year and I was looking at stuff in the basement this weekend and developed a question. BACKGROUND House has a interior perimeter drain tile (dry basement system). 2 sump pit basins. Each with a battery backup. I had the water softener replaced in July...

Got it all replaced. Picked up the water pressure gauge. And propped a scrap piece of wood under the pipe for support. Thanks all

got it removed. Picking up new one later today and will put back on tonight. Thanks for help guys!

Ok. Getting the floor wet during removal isn't an issue its just bare concrete but ill keep that in mind.

I had considered something like that as well. Any concerns i should have in removing the tank from the copper fitting? Just take it easy i assume?

Ah thank you. I'll pick up a new expansion tank and get that changed out. I'm not shocked its bad because the previous owners of this house appeared to have decided to move rather than fix the issues (mostly minor but many in quantity) that the house had. Which is ok, I do enjoy learning and...

No the expansion tank valve is pointing up. I am on well water not city if that matters. When the water heater was running just now and I tapped the expansion tank it did not sound empty or hollow in any way. It made a very solid full noise Should the expansion tank pressure be checked...

My expansion tank reads at about 45psi. If that matters

Hi all Just bought our house in June. Since then I've found the natural gas state water heater ( 3 years old) leaks out of the pressure relief valve ONLY when one of the bath tubs is used. It does not leak any other time but when we give our daughter a bath. There is an expansion tank...

Its for sure 100% violet (purple). Had to remove and clean the other day since it wasn't drawing in the brine.

Can do. I'm off today and its rainy and windy out, so this is a good activity for this afternoon.

I add this religiously each time i put salt in. 1 bag of salt, then I sprinkle like 1/2 a cup of this on top of the salt. I forget the amount I have and old little cup that I measured out a couple years ago with a line marked on it with the amount to add. Then I add another bag of salt...

I honestly don't recall. this was like a year and a half ago. I just remember calling support, they had me remove the part and look at the "button" I just remember that is what it was called. Whatever was in there was too big, which I guess caused the resin to get flushed out? I don't fully...

The other day when I was having trouble with the brine drawing from the tank. There was about 10 inches of water in my brine tank (see above post I think the last time or two the brine wasn't drawning in properly due to injector issue?). With the 60 minute draw time it was basically empty when...

I just want to revisit the settings to ensure they are good. As initially configured I had the incorrect "button" for the drain control? So i lost a lot of resin out when the unit was regenerating. So changed the button out to the correct size. Not sure if that has any play in the...

Hi everyone. Looking for some help to confirm best settings for my softener setup. Its a fleck 7000 sxt. Have 2 adults and 2 kids in the house. On well water. Water hardness was measured by a local company with a dropper kit, that hardness was 21. With iron level of 2. Softener is a 48k...

fair enough. I just want a place to start or have an idea to what the issue might be if I start to call for quotes to fix this. The banging is besides annoying probably not great for the pipes in the house to experience I'm sure