Search results

Thank you all so much for the help - This has been bugging me since last summer, so I'm glad to finally have a meaningful fix in place! @WorthFlorida I'll try out those tests. The controller model is a Hunter IC-600, which I think is an older model - if the issues are stemming from the...

I think it was the solenoid, but I also replaced the diaphragm while I was at it

So I found the valve box for that zone! I replaced the solenoid and diaphragm, and used water resistant wire connectors (the wire connectors that were in there were standard non-water resistant). The zone ran fine during the cycle, but did stop / start 2 times in the last minute of the cycle...

Thank you! I tried swapping the wires with another zone and running a brief cycle, confirmed its still happening. My next step is going to be trying to find the control box for that zone, so I can try swapping in a new solenoid. If I borrow a metal detector do you think that would help me...

Hi all, hoping I can find some help here! I have a Hunter controller for my irrigation system. There are 6 zones that are programed to run one at a time. The 4th zone will suddenly lose pressure and stop mid cycle, the heads drop down, then start back up seconds later - and then the process...