Recent content by Still_Learning

Alright, gotta bump this again because now that I'm into it, there's not a good wall nearby where I can send the dry vent off the toilet with a vertical takeoff. If I change to the layout below, can the toilet be served using a wet vent from the sink as in the diagram below? If so, does the vent...

That's good to hear! Thanks @wwhitney! Bonus question for you or anyone else happening upon this thread: If the wall was open and you had 60 year old copper water lines, would you: a) leave them alone b) replace them with PEX-A c) replace them with new copper

Love this forum and everyone's willingness to share their wisdom . Bought a house a couple months ago and the kitchen/laundry branch line drain had no bottom (rusted out cast iron). Since then, we've had that pipe lined with an epoxy sleeve and now have a working kitchen sink again, but before I...

This project took a little longer than expected but I’m most of the way there I think. I used clear primer and heavy duty PVC glue. I plan to test the drains multiple times before putting everything under concrete but I can say the connections from the above fixtures are running well to the main...

Glad this will work! I didn't think about option #0 but I think #1 will allow for a place to tie in drain F after D/E without having to run it all the way over to the main. Again, appreciate the help.

Routing the basement shower between the basement lavatory and basement toilet was probably 8" over the 6-foot UPC guidance, so my new plan is to run a vent line up the wall from that shower drain (B) to tie into the E drain dry vent that goes out the roof. This is represented by the purple line...

Okay, I lied. I do have another question. Does drain E need to be 4"? Couldn't it be 3" or even 2" and still adequately vent the toilet, shower, and lavatory? It's 4" CI where comes out of the slab and where the lavatory currently drains into it then transitions to 2" halfway up the wall and...

Got it. I'm going to try to lay it out tonight and take some pictures. I'll open a new thread for the kitchen/laundry situation.

My bad, will do it better in the future. Do you mostly mean drain F? I can probably excavate to tie it in to the main where it currently is. It's not that much more work I suppose. If I did that, I'd just use two more no-hub couplings to tie in and still have the section after that lined...

Assuming the new diagram is acceptable, is there any issue with that many fixtures/pipes joining in such a small area or anything else I should watch out for? I could probably run F back in it's original configuration to the main lateral and/or run the B, D, and E group over to the main lateral...

Appreciate the help @wwhitney. I will need to think about this a little more. For some reason I was under the impression that B could be vented by A as it is currently set up. I'm on UPC by the way. There are 4 vents that go through the roof within 10' of this bathroom so surely I can work...

Sorry, in this case by 1st floor I meant basement. I understand how that could be confusing. Edited post to clarify.

Hi, all, This forum has been very helpful over the years and while I mostly just read, this time I need some help. We moved into a house with a collapsed kitchen/laundry line. I excavated it and the 3" CI pipe has no bottom. I had a plumber come out and he said they could clean it out and line...

Awesome! Thank you both and hope you are having a great Christmas!

Alright, I'm about halfway into this project now and things are going alright but I'm not going to keep saying this is my last question (ha!) because who really knows what I'll run into. Two new questions with diagrams! 1) When tying a horizontal drain into the main stack, do I have to use a...