Recent content by Scottb022563

  1. Scottb022563

    Possible Bad Control GE GXSF27E

    Gary, thanks for input. I am weighing the fact that I have already spent a lot of money unfortunately repairing my softener. At this point it is pretty much brand new with almost all of the prats replaced except the brain. Thanks agian. I was able to get another control and wiring harness...
  2. Scottb022563

    Possible Bad Control GE GXSF27E

    Gary, thanks for the reply. I understand it is not the resin, originally I had bad resin and just passing along all the changes I made. I am just asking if it could be anything else besides the control( or circuit board) at this point. I am ready to buy the circuit board but it is $200.00...
  3. Scottb022563

    Possible Bad Control GE GXSF27E

    I am getting error code 1 on my ge softener. It is 6 years old. I have replaced the resin, seal kit, disk rotor, switch and motor and am still getting the error. I get the error even if I run the unit in bypass mode. I also get the error even if the switch is disconnected. It always stops...
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks