Recent content by Ryan98270

Also, I did use copper everywhere except the overhead faucet. I got away with using a single elbow joint in that entire run, and ill be sure to insulate the 2 feet of pex in the attic. Its already sitting below the blown insulation on top of the sheetrock. Thanks for all the suggestions

Can I get some opinions on this soldered joint? It doesnt have a liquidy beed like my others, but its holding water for several hours now. Im just not confident in how it looks. I used tinning flux and a 1/2 inch solder. Am i fine to close the wall up if no issues for a couple days? If not, can...

Thank you for the response. I found the R22000 rough in valve which appears to be integrated and have the ability to do what im looking for... I guess the rainshower doesnt need a lot of pressure, I ordered a showerhead designed to mimic rain, not a full body spray. I was hoping to confirm my...

Looking at delta r22000 with trim for 3 way use (A, B, A+B) and running pex up to the attic then over to rainfall location. Do I have to elbow it once in the attic or can I do a a couple alow radius bends with those plastic pex benders (to try to minimize pressure loss). Does the pex have to...

Hi all! Hoping to get advice on how I should run this setup. Mostly getting confused on the valve choices.. The shower is currently opened to the studs and we wanted to take this opportunity to add a rainfall shower head in the ceiling. Its a shower only and currently plumbed for a single 45°...

Here is what I went with... Sinks are 44 inches apart so it's a little funky.. Rough ins are at 21" to the center of the pipe opening... Is that ok? Also the lowest drain fitting I used is a combo is that a problem? I also put too much slope on that horizontal line, 1.5" over 18" run... Will...

Thank you! Without the added piping you drew I may end up with venting or code problems right? I feel more comfortable with your solution and is likely exactly what im going to do. I assume the vent pipe needs no slope and the upside down santee is for future snaking..

I see these 2 diagrams for 1 1/2", how can I apply this with my current setup? The 2nd picture would work but both sinks will be to the right of the drain/vent

Hello Ive studied the related threads on this topic and I'm either too novice to understand how to apply the solutions provided, or my setup is different. I chased a leak in my bathroom which led to me remove flooring, vanity, drywall, etc. Now I want to replace it with 2 sinks and need a little...