Recent content by randolph56

A few weeks ago I had a service call to a house where the woman had some lightbulbs blow up some only dim her surge strips melt and her fluoresant ballests burn up. In her case the neutral wire(old aluimium seu) disintagrated and could not carry the load of the furnace, refig, etc motor load...

I saw the piping diag. Total loop is 30' right now. There is a 6' on the 2nd floor bath and 24' on 1st floor DR.(total loop pipe, supply header to return header is just over 65') The TK would be in between the 2. Like stated there is a BG Little Red circ on the loop.

Good morning all. I have a question about installing a toe kick heater. I'm renovating the kitchen and removed an electric forced fan wall heater. I want to install a Beacon Morris 84 under 1 of the cabinets. The zone is a 3/4 supply with a flow control and a circulator(single pipe). I plan...

gas size Thanks for the replies. After I posted and then did some more searching I realized that I didn't give enough info. From the link I figured what cfh was needed and the capacity/volume of 3/4 with the length and # of 90's etc. So, yes in my case 3/4 will handle what I need, but just to...

Good morning all. Don't know if this is the right forum but here goes. I want to replace my current 40 gal NG water heater with a power vent model.(AO Smith GPVD40?) The current heater is next to the boiler sharing the flue and about 40' from where I need the hot water. I want to move the WH...