Recent content by Pops52

So, on my 10 year old 7000sxt, water seeped from somewhere towards the circuit board and shorted it out. Been having some valving issues so thought about a new replacement head with controller. Any idea where I can get one? All I see on "that place" are for a 5600. Probably due to replace the...

What would you recommend? We will only be using 1-2 gal/day.

I'm in the market for an under sink RO system. Well water is drinkable but dont like the taste after softening. Only 2 of us and probably using less than 5 gal/day. I'm looking at the Ispring RCC7AK but dont know much about this RO stuff. Any thoughts ?? Oops, forgot to paste this in. iSpring...

Thanks guys. It has been HOT here in N Calif. and the garage has been 90-100’. I’ll recheck air pressure in the early am with cool water in tank.

Thanks @Reach4 , I checked precharge and it was 50+-, I dropped it to 40. Down hole pump. Control box less than 1 yr old. Pressure tank is 25 yrs old so ruptured bladder was my 1st guess. No water came out of schrader valve. I might just get a new tank and have it ready.......

Recently, I have noticed a change when my well pump starts. 62 gal pressure tank set at 50/70. When the pressure draws down to 50 and the switch closes, for a split second there is a drop in pressure to 40, a small "jolt" then back up to 70. Never noticed this before last week, and now during a...

I think my issue has been resolved. There was some salt/brine residue on the encoder and it was at the spot that was where the "reader" was supposed to stop the cam, so the cam went another 1/16th" and the brine valve closed stopping the draw. I HOPE this was the reason. I ran a cycle and it...

Here is where the brine valve shaft was at during brine draw.

Yes. That's how it is now and that's the position it was in (on the other lobe) when it was in brine draw mode.

Good Day Couple days ago the brine draw stopped so I did the usual cleaning of the injector. It wasn't plugged like it usually is. Still wouldn't draw any brine. Pulled the cover off and watched the cam rotate from one sequence to the next. As the cam rotated to open the brine valve, I saw the...