Recent content by pastorerik

Thanks for the replies....I will check and lube the motor.

Not sure exactly how this one works, but it is set up so that the fan does not come on until the heating element is up to temp so that it doesn't blow cold air. Plus all of the fan forced heaters I have seen (I have a couple of different ones) the fan shuts off (as well as the heating element)...

I have a fan forced electric wall heater in my bedroom, that I installed new when I built it (about 10 years ago). (Fahrenheat/Marley FZL4004B, 4000 Watt) Recently it started doing something strange. Intermittently the fan will slow down, almost like it was on a speed control turned way down...

Thanks for all the help, I will try the teflon tape. Can't do anything about the riser being cpvc, it has been in there for years with no problems so far as far as cracking, etc. It doesn't leak as long as it is tight enough, the problem is the alignment is about 1/8 of a turn too far. If I do...

I have cpvc pipes. At the top there is a threaded fitting with a rubber gasket inside. My question is how to get the angled shower head pipe in so that it is tight enough and lined up. Mine needs to be tighter but would need another full turn to line it up right, I am afraid it will either...