Recent content by oreyes

Just an air handler. thanks.

This is a Lennox unit - I'll check the manual again - the manual referred me to the Standards cited and to local codes. Thanks for the input.

This thread is related to my previous post. Trying to find minimum acceptable clearances for air handler install. Am wondering whether my unit should even hed been instaleld where it is. Mine is in the peak of the attic on a cape and its insanely tight. Had issue that caused drain pipe to be...

Info on Mimimum Clearances for HVAC Air Handler Install First of all let me apologize for not updating you guys sooner. The disaster happened in my office - I've been w/o phone service and w/o internet for the last two weeks since the second floor was in containment; twice for mold abatement...

EZ Trap http://www.eztrap.com/documents/installation_instruction/SV4-ENG-ezt626-039_9f.pdf http://www.eztrap.com/documents/products/S1H-Product-overview-600series.pdf Wiring diagram / product lit for the EZ Crap product - Sorry EZ trap This is the closest I could find to what I have...

Talked to the installer /service contractor. A visit by a tech will be scheduled. He said the pipes get blocked usually by spiders or other critters. Which is true, but he did not have a good answer when I mentioned the microswitches and asked why they failed and how come the secondary was...

The I guess it's possible that the drip pan cracked during install after the unit was set on it and the installers did not replace it? The secondary pan seems kind of flimsy to me. If the issue is not discernible from the pictures I'll proceed to the water test. On the second picture is that...

Pics! Hope this works... If anyone is wondering - This was done with IRFANVIEW - it was quick and easy. Thanks to all that have helped with this. It is very humbling to see how well these communities work, I hope I can be of help to some.

Thanks for your help Mike. Here's some more info. There is only one pipe outside the house. It is the one connected to a P trap with a micro switch and it goes into the housing of the unit. There is also a 3/4 inch pipe connected to the drip pan about 18 inches down from the p trap but it is...

Makes sense to me . the crack area flexes more than a politician negociating 5 different bills. In the not so long term there's only one answer. Thanks for your input.

At this point only because its done. But I reckon if I was going to do over that would be it.

Hello all, Back in July my AC unit leaked into the ceiling of the 2nd fl. The service people cleared the clog from the end of the pipe by blowing nitronen I believe. No probem since then. I'm puzzled however due to the fact that the drip pan under the unit was not wet at all and the water...

I have a hairline crack that runs about 7 - 9 inches and it flexes and opens up when I step on it. (I know... don't step on it) . This shower enclosure from around 1986. This in on my second floor bathroom and the first fl bath is under remodel and will be for a while so I do not want to do...

Help.... I'm a homeowner who soldered my first pipes just a couple of weeks ago. I recently converted from a shower-tub to shower only. To get the proper depth for my shower valve I have to push them into the wall about 1/2" and am concerned this tension may weaken the joints over time...