Recent content by Mplsavant

  1. M

    New Design for Hyrdo Air, Arm Tank or stay as is?

    Hey Master Plumbers, I could use some advice. Trying to determine if we should change up our 7 year old design in our house. Here are the specifics and a picture. Buderus GB142 (no outdoor reset since installed in 2005). I have an AM10 but have not installed yet. Zones: 1) Air Handler 2) Arm...
  2. M

    Buderus gb142 - Too High Supply Temp

    Badger - Saw you drive by Kowolski's in Woodbury this a.m....was thinking, maybe I will call them to take a look at my boiler as another pair of eyes (install and all service has been by factory trained Buderus techs btw).....after your ego above, I don't think I will be calling...... I was...
  3. M

    Buderus gb142 - Too High Supply Temp

    Forgot to mention.... I don't have the outdoor reset/controller....unit was installed in 05'.........I did a test last night, called for heat for 1st level....if I have the temp set to AUX it goes to 194.....if I turn it to 170 it only heats the water to 155, so like 15 degrees short of the...
  4. M

    Buderus gb142 - Too High Supply Temp

    Hey all.....I was getting an "OY" error message on my Buderus GB142 - supply side water temp exceeding 199 degrees.....my heating guy replaced the pump for the DHW with a larger pump and it has not gotten the "OY"...it reaches 196 which I think is still high....wondering if this was truly the...
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks