Recent content by Joe Berni

I finally solved the mystery. The pipe is from an old company named Rain Jet (acquired by Toro). The pipe is one-inch CTS polyethylene tubing. without the usual markings. The ID is 7/8" and there is a part specifically for connecting these older pipes to 1" poly, which I found under the name...

Could it be schedule 10? ID I found for 3/4 schedule 10 is 0.884 (my measurement was 0.8835).

Thank you Reach4. I purchased a caliper today and the OD is 1.07" and the ID is .88". I tried PEX fittings without success. WorthFlorida, thank you for the great idea. I loved the idea about using the existing pipe as a conduit, but unfortunately there are likely 90 degree bends and I already...

Hello everyone, I recently purchased a new house and replaced an old system with a new sub-surface drip irrigation system. One zone required that I use the piping from the old system because it passed under a large flagstone patio, leaving me no way to bury new piping to this front yard zone...