Recent content by jamiedolan

A note about your flooring: Tile for a bathroom isn't normally very many sqft, so it should not be too expensive to have professionally installed. I'd hire someone for the tile install since you don't have any experience. Tile done wrong (not level, poor spacing, etc) looks horrible and isn't...

That pipe is less than a foot underground, do you think it should be dug up and replaced or at least inspected? What kind of pipe is it that feeds the gas meter from the gas co? Here it is some kind of metal pipe that comes straight out of the ground that is normally painted grey or the color...

Hello again; The pipe you see that comes through the concrete is my main gas line that comes into the house, this is direct buried. It looks more like galvanized to me. It is wrapped on the outside. It was installed in 1963. I'm not trying to argue that it is correct by any means, just...

I must be confused or they approve of using different materials here for some reason. When my dad built his detached workshop about 5 years ago, he used the standard black epoxy coated pipe that you see at all the home centers, he buried that in the ground, doing nothing special to the joints...

Now that you say that, I am quite sure this is not really iron and I am using the wrong terminology. I am sure the pipe I use is the epoxy coated steel pipe. Do you apply something to the joints beyond a thread compound(retorseal, / harvyseal) prior to applying the pipe wrap? Thanks Jamie

1. Bathroom outlets need to be on a 20A circuit that is just for bathroom outlets, if it is just used for outlets it can be shared with multiple bathrooms. Or you can have the entire bathroom one one 20A circuit, including the lighting if it is not shared with other bathrooms. 2. GFCI outlets...

Hello; I'm running a new gas line to my outdoor grill, 24" deep. I've never buried gas pipe before. I've installed quite a bit of black iron inside, and am completely comfortable with laying and fitting the pipe, including pressure testing the system. It is also legal here to perform the...

Excellent. Thanks again for helping me get this figured out! jamie

Cool, perfect solution, I'll hunt one of those down and install it. Do you think I am ok making the dishwasher hose a few feet longer if necessary? Thanks Jamie

Ok, will do. Do I need the Air gap to be exposed just above the sink as was shown in a photo here, or can the same thing be accomplished just below the sink where it will not be exposed? Thanks very much Jamie

Thank you both for your responses. If I route the drain hose under the cabinet base to the main sink base, it won't really be a very long run. If I need a couple extra feet on that dishwasher hose to reach to the disposal, can I just replace the dishwasher hose with some of that flexible...

HI guys; I've made a few posts here in the electrical forum, new to the plumbing area. I hope you can help me out with a question on the drain setup for my new kitchen. Thanks much in advance. I am doing a full gut and remodel on my kitchen. The main counter will be a U shape design...

If a plastic box is UL listed as a fixture / junction box, then it is fine to use for either. Use the correct box where necessary and it is all legal, metal or plastic. Jamie *I am pretty sure there are some schd 80 plastic rated for exposed work, but am not positive, I use metal.

No offense intended to the OP or anyone else. Frenchie; I just wanted to say I agree with you. I have experienced and tried to explain this to people I know in real life and some people have a really hard time understanding my point. It's kind of a question of what your skilled at, if...

By 2 3 way motion sensors for $17 each at Lowes or *******. I believe the brand they carry is rated for non-lighting loads, but double check the package to make sure it is ok to install something other than just a light and that you are in the correct amp/watt range for the motion sensor. Not...