Recent content by jacksmith7

Isn't it vented by the shower vent? Thanks.

I wonder if no response means the rough-in is okay, or it's so bad no one cares to comment. :)

Please look at the attached picture and tell me if my rough-in is correct. Thanks.

Thanks, HJ. Maybe I can find a combination of fittings that will give me the angle I need.

I'm in need of an irregular bend. Does the code allow heating and bending DWV PVC as long as it doesn't kink?

Great point...thank you.

Plumbing and electrical are included with the building permit.

Not requiring inspections is not uncommon for many small towns in the midwest. Thanks to comments from everyone here, I think I finally understand. I'll connect the sink to the shower vent and vent the washer by itself. The shower drain will tie in between the toilet and the washer drain. I...

I appreciate all the input on this, and I apologize if I seem dense, or have created confusion. Attached is a rough sketch that I hope will better illustrate what I want to do. The vent going to the shower drain will run under the slab until it reaches the plumbing wall and then become vertical...

I'm not sure I understand. The shower vent would continue to run along the ground until it reaches a point (the wall) behind the toilet and then go vertical through the roof. The stub of 2" pipe sticking out of the fitting in this mock-up is just to show the direction the vent is running. The...

Please review the attached picture of what I mocked up for our pole barn bathroom and let me know if it is correct. Thanks for any help/advice.

Any answers to questions 2 and 3 would be appreciated. Thanks.

Thanks to all who responded with advice. I'm going to tear out this whole mess and make the following changes: 1. Replace the 3x3x2 sanitary tee going from the main line to the shower trap with a combo fitting. 2. Replace the backwards sanitary tee for the shower vent with a wye fitting + 1/8...

The 3x3x2 san tee connecting the shower to the main line was already there when we completed the rough-in and was (supposedly) installed by a plumber. Since you emphasized "SHOULD", does that mean the shower will still drain okay with the 3x3x2 san tee but it is just not to code? Thank you for...

Thank you. I clarified my original post.