Recent content by hj

  1. hj

    Water between the tub insert and tub?

    A motel had all its tubs relined, and after about a year half of them felt like you were waling on a water bed. The only way I could see for the water to get in was where the liner met the walls and shower water was seeping in.
  2. hj

    Replacing shower/tub fixtures and can’t figure out what brand this is

    Moen
  3. hj

    Noobie asks ... Such a thing as a cartridge stem extender?

    IF you installed the valve correctly and needed the extender kit, there is no way you would just need the one part, since they are a "package deal" and go together.
  4. hj

    Drain rollercoaster

    Especially if you do not care that it might not drain at all.
  5. hj

    Whats wrong with this DWV iso drawing for basement bathroom?

    You also need a shower vent.
  6. hj

    How to connect b-vent to transite on WH change out

    Is there some reason you are using B vent? standard single wall pipe fits into the Transite.
  7. hj

    TPR valve on water heaters.

    They wee picky around here and considered corrugated undersized.
  8. hj

    Price Pfister Valve Identification and Replacement

    It does look like a Pfiister Avante vale and if so, you need an Avante cartridge available from 1-800-PFAUCET (free replacement), or any hardware store.
  9. hj

    S-traps

    They can sell anything they want ti. It is up to the user to the user to comply with the ordinances.
  10. hj

    check valve leaking??

    That is NOT how you test it.
  11. hj

    How do I get this shower handle off?

    Then you need a smaller hex wrench, because that is where the screw is.
  12. hj

    New here, hope posting right. Advice or kitchen faucet needed

    "Thingan]mabob" doesn't cut it. WE need a picture or faucet manufacturer's name.
  13. hj

    On-Demand Hot Water Circulation

    I am sure your flow velocities are off the chart. You will probably encounter a lot of erosion, and therefore leaks, at all turns where turbulence is highest. The PEX insert fittings may also be a problem at high velocities.
  14. hj

    Sdr 35 fernco fitting

    Cut a coupling in half and glue the pieces to the pipe. That will make it the same size as a sch. 40 Fernco.
  15. hj

    Please advise ! Currently trying to remove it

    apply heat while applying slight rotational pressure. When it reaches the correct temperature it will easily unscrew.
See more
Top
✖
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks