Recent content by gsici

I am moving my kitchen sink to the opposite wall and as such I will run new drain into the basement and connect to the main drain and vent into the attic and connect to the main vent. The question is with my sink under the window which is the best way to vent. I am used to wet vents going...

Thx John and Jimbo I inserted the cartridge and the problem is resolved. The whole idea of the blank plug for us DIY'ers makes sense since I am sure I will get mud on the cartridge and bang it around a few times before the project is over. I just wish they would have cautioned us against this...

Thx John. Just so I understand. The hot and cold are mixing in the valve body and then bleeding back into the hot supply line when I turn another faucet on?

Just want to add new info. It would seem that hot water in the whole house is not working unless the newly installed faucet is running.

Dear Forum readers you have helped me int he past and hope ypu can help this DIY'er again. I spent the weekend gutting my upstairs bathroom (4 piece) and installed a new Delta Shower/tub faucet. During the weekend my wife needed to use hot water and she realized there was no hot water in...

Great. Thx JW On another note BimmerRacer's steam generator doe not call for GFCI (nuissance trip) the one I bought however calls for one. Why this difference of opinion on something that I would consider a lifesaving device?

I have read on many threads and I believe it is code in some areas that the total connected load should not be more than 80% of the rating of the overcurrent protection devices. Is this correct? Should it be less of a concern since the steam generator is the only load on this circuit?

What about the 80% rule. Bimmerracer's steam generator seems to have a rating of 46 AMPS. Would it not be code to pout a 55AMP breaker?? even-though the manufacturer calls for a 50AMP? I will not hijack this thread but the answer will be important since I am in the same predicament with...

Howard I think you are bang on. Just got back from Homers and spent some time with someone that actually had some idea (miracles never cease) and after spending time through several vendor catalogs. I need a temperature valve and two separate volume valves. The two separate volume valves are...

Thx all. I guess using the tub spout is a no-no. Howard the Alsons product is external and I plan on having a showerhead from the ceiling and the slidearm with handhels will be on another wall three feet away and I do not want to have long cables on the outside. I think volume controls...

Most of the big box store carry a valve with a built in diverter on the tub spout. I did see one however on the valve and I was thinking that I could use one for the showerhead and the other for the handheld shower since I do noy have a tub. Is this a fair assumption??? If so can I put the...

Thank You. Pictures do speak volume. What is a STOP on a pressure balanced valve?

Thanks all. I think I am ready to make some connections.

THX HJ I have no other valves. I have nothing at this stage. Are you saying I need to buy two components. A 3 port diverter and secondly a valve? If so what type of valve?

WOW. I have walls down in the basement for a new shower and was looking for a new shower system and realized that this has come a long way. I always knew of Diverter and that's all I thought there was, BUT diverter, transfer, multi port, thermostatic, mixing, pressure balanced, volume control...