Recent content by flazoom

I am having a problem with my irrigation system not working. The pump seems to run ok but none of the zones are working. The water for the system is taken from a lake and is fed via a 2 inch PVC pipe. The system is about 15 years old and the pump has been replaced once as has the timer. This...

I am installing a double sink vanity in my master bath. The new sink drains no longer line up with the waste pipe in the wall. Can I use a 990 degree bend coming out of the wall to route the drain line along the back of the vanity and have the ptrap face towards the back as well? I know I can...

Thanks again for the quick responses.. The flange itself is PVC. I have seen an 'extended closet flange' when I searched online that is about 6 inches long and 3x4 size which would fit my waste pipe. Since the inside 'collar' of the flange (it is set inside the 4 inch waste pipe) looks to be...

Thank you for the response. I do not have access below the floor without removing part of the tiled floor or ripping out a ceiling from the first floor. I have already replaced flanges in 2 of my bathrooms. One half bath that was on cement slab where the flange was not screwed or even glued...

Hello, While replacing the third (and final) toilet in my house (2 Toto Drakes and 1 Soiree) I found that the closet flange was not screwed to the floor and was tilted about 1/2 in. The back of the flange touches the floor and the front is raised about 1/2 inch. The toilet I removed had been...

Thak you for the responses. My house is around 2000 sq feet (1,934 to be exact) under air. The A/C is a 13 seer unit. Is this the 'size' information? (I don't know too much about HVAC as you can see) The house was built in 1993, the interior air handler is the original (RUUD) and the outside...

Hello, I live in south Florida and run my AC pretty much year round and have a question about the ceiling AC ducts. All my ceilings around the ducts are wet to the point the paint has bubbled a bit. There is no dripping but the ceiling drywall is quite damp when I removed it. It is only around...

Thanks for help. I just wanted to thank all who responded to my questions. This past weekend I attached the waste pipe to the joists and strapped it down as well. The pipe now has the correct slope and is no longer 'loose'. Now I move on to adding underlayment to get ready for tile. Thanks again.

First off thanks for moving this thread. To determine the 1/4 inch per foot slope, is it valid to set up a 2 foot board (assuming I find a straight one) with a 1/2 inch spacer on one end and then put a level on it. If I then note where the bubble is on the level and then put the level on my...

am I on the correct forum ? I just realized I may have put this thread on the wrong forum, toilets instead of the general plumbing forum.:confused:. Is there a way for a moderator to move it? Or is it ok here?

I was able to cut a hole in the sub floor around the waste pipe this morning. The pipe is strapped (metal strap) to a 2X4 that is not attached to the joist. It is long enough that apparently it was resting across 2 joists to support the waste pipe and keep it from resting on the ceiling below...

Looks like I'll cutting some more subfloor out this weekend. I'll remove the existing flange and add a stub while I am at it. Thanks for the help.

I won't be able to tell how or if it is supported without cutting out a piece of subfloor. I was hoping to avoid this since there is no damage around the floor where the toilet was. The toilet has been in use for the 13 years we have owned the house with no problems (at least not yet). I did...

This is a great forum that helped me to redo my half bath about a year ago. Now I am on to my next project and have new questions. I am retiling a master bathroom floor and when I removed the toilet and old tile I found that that waste pipe for the toilet has at least 6 inches of vertical...

Last year I remodeled a half bath and installed an ADA Drake. We have been very happy with the toilet and plan to use either a Nexus or a Soiree in our Master Bath *currently under remodel). I have searched the forum to see if there were any comparisons of these 2 models without any luck. Does...