Recent content by fingerusarthriticus

ahhhhhhhhhh :eek: I am sorry, but are there no comments regarding the "easier than a lightbulb" light sensor replacement job coming in at $350!!!

Is it a lack of water in the tank itself? I am no expert so get your "grain of salt" out. It would seem to me that you could heat a small amount of water and a lot of air to the stop temp in 4 to 5 minutes, but not a large amount of water. I would try adding water to the tank, opening the...

I recently decided to do my own service on my Carlin EZ-1 SO-105 burner. I changed the filter (messy, but doable), Cleaned the soot out, changed the oil motor filter, and changed the fuel nozzle. I used a .65 60A degree instead of the .75 60A degree I found inside and reset the EZ air/fuel mix...

recently decided to do my own service on my Carlin EZ-1 SO-105 burner. I changed the filter (messy, but doable), Cleaned the soot out, changed the oil motor filter, and changed the fuel nozzle. I used a .65 60A degree instead of the .75 60A degree I found inside and reset the EZ air/fuel mix...

I recently decided to do my own service on my Carlin EZ-1 SO-105 burner. I changed the filter (messy, but doable), Cleaned the soot out, changed the oil motor filter, and changed the fuel nozzle. I used a .65 60A degree instead of the .75 60A degree I found inside and reset the EZ air/fuel mix...