Recent content by electrichillbilly

looks like the first thing you gotta do is bury that cast dain line. depending on whats up with that you can change and reduce to pvc the drain your ytalking about whas to be raised to the new floor height, also it will lokk like a true hack job if you tile around the hw heater. odd shaped room...

i believe the instruction refer to remove the valve from the housing to eliminate any damage to ther valve during soldering. by the way, if you use mapp gas it is much hotter than propane which makes soldering very quick and easy

yep, boiler is reaching set temperature probably 180 degrees, then shuts down, circ pump will continue to circulate until room thermostat setpoint is reached, in the mean time when the boiler water temperature drops to the set temperature probably around 170 degrees, the boiler will fire up...