Recent content by Dajack2125

Another question. As this pump is going to be for watering outside plants only, is it possible to hook up a garden hose bib to the discharge line of the pump, without having to use a pressure tank? If I am understanding correctly, the on/off rapid cycles of a pump is what does the most damage to...

The old pump is a Meyer pump. It is 120V three wire pump, 1/2 hp.

No, it is 120v

I moved into a home that at one time had a submersible pump. Township ran water and sewer lines and forced everyone to hook up to the new lines. The pump sat unused still in the well for quite some time. Township has kept on raising water rates and will continue to do so because their is...

Thanks for getting back. The piping on the left side of of picture that is going into the ground on the front of the pump. Is that where I would make my connection to my totes? Then on top of pump is where I would connect my fitting for my garden hose? I tried a little 12v pump, and as you said...

Hello, I purchased some IBC totes for harvesting rainwater. This water will be used only for watering the garden, trees, shrubs, plants around our house. I was using just gravity feed, but would like to install a pump for better water distribution. The pump I would like to use would be connected...

In response to your post. I have a double pipe system. It is a convertible deepwell jet pump. It is listed as being able to pull from 90'. Second, the township laws mandate that all residents be connected to city water.

I have a deep well with a 6" casing. There was a submersible pump that went bad. so we have ignored the well as we are getting city water. City water is way to expensive for watering the garden and our trees. I have a Wayne CWS50 convertible jet pump that I would like to use in place of the...