Recent content by Boycedrilling

I normally install a 60 amp service to a sub panel in a domestic well pump house. Unless the pump is 3 hp or larger. You have to pull 4 wires to a sub panel. Two current carrying conductors, a neutral, and a ground conductor. To be NEC code compliant, you need the branch circuit for the pump...

Compare water velocity to driving a car. Your driving down the road at 30 mph. You hit the brakes, how far does it take to stop? Now the same thing at 90 mph. It takes a lot more than 3 times the distance to stop.

You also have to remember 1" pex is NOT the same size as 1" pvc or poly pipe.

I'm out of town, but I just looked at franklin pump curves online. If you do have a 2 hp franklin pump of ANY of any gpm rating, your pipe is grossly undersized. Even an 2 hp 8 gpm pump will flow 11 gpm or more at 50 psi, from your water depth. Your pump and your water lines were mismatched...

You want to keep your water velocity in a pipe, 5 feet per second or less. In one inch pex that means a maximum flow of about 8 gpm.

Good chance that the 1" pex from the well to the house is the culprit. Water velocity is too high.. 1" pex has approximately the same inside diameter as 3/4" pvc or poly pipe.

Here’s another before and after

Here’s a before and after when I replaced a pressure tank earlier this year. Only thing that’s the same is the 1 1/4” galvanized tee

Your city will have specific requirenents for yard irrigation. With city water. Check with them.

Probably a majority of the wells that have a pitiless adapter and a sanitary well cap like yours have a splice inside the casing made up with wire nuts. Does it meet NEC code? NO! The National Electric Code categorizes the inside of well casing as a "wet location" . This means that the wire...

I like to backflush the well with at least 150% of borehole volume. So I either use a tote tank (275 gallons) or my water truck that holds 3,000 gallons.

Search watertight well cap..... Walmart Home depot Lowes Menard Amazon Etc. Get a good well cap on. Do a flooding chlorination then retest your water.

Ok, you want to know how to do it correctly? First take that old non-sanitary well cap off and throw it away! Your well casing needs to extend 12" to 18" above grade. Buy a sanitary well seal. It will have a top and bottom portion, with a gasket in between. The bottom portion will have a...

Take your advice from the professionals only please. Galvanized or stainless steel drop pipe ONLY. BECAUSE OF THE DEPTHS. This is beyond the depth ratings of sch120 PVC or poly drop pipe. No you cannot use a lighter material at the top. And you may have to go to 1 1/4" sch 40 galvanized drop...